It is pretty obvious that NAT is needed to make this possible, but Internet Connection Sharing is inadequate in this particular case. I wanted to enable other computers to dial into A via a modem say (or in my particular case direct-cable connection) and thereby gain access to the Internet. I had a machine A, running Windows XP Pro, which had access to the Internet via its single network card. Here is an actual example scenario where I have successfully made use of this feature: To use them, one must use command line configuration tools, specifically "netsh".Īnything that can be configure on W2K Server using the GUI interface can also be configured in say Windows XP using appropriate commands given in netsh. However! The features are actually there and fully working. This feature is missing in Windows XP etc. Under Windows 2000 Server to configure these features one would usually use the Routing and Remote Access Service snap-in in Microsoft Management Console, usually available via the Administrative Tools in Start Menu. The only thing that is missing is the appropriate GUI components to configure these options.
Netsh routing ip nat install windows 7 full#
in Windows XP and W2K Professional.Ĭontrary to what the majority of the posts claim, the full RRAS service including all features such as IP routing and NAT is actually available in Windows XP, W2K Professional etc., not just in Windows 2000 Server products. Having looked around the site, I have seen many posts involving discussions of the Routing and Remote Access Service, Network Address Translation, IP routing etc. This post is about the potentials hidden in non-server products such as Windows XP, W2K Professional etc.
Netsh routing ip nat install windows 7 pro#
is actually available in Windows XP, W2K Pro etc.Īsked by rzoli in Miscellaneous Networking, Networking Hardware Firewalls, Dynamic Host Configuration Protocol (DHCP)